Precautions for purchasing and using biomass burners

In order to ensure the safe and normal operation of the biomass burning machine, it is necessary to perform the following operations:

First, operation management:

1, according to the user's raw material consumption law appropriate addition of fuel to ensure the normal operation of equipment;

2, the feeding speed to 3080 as a conventional amount, the fastest does not exceed 100 speed, the slowest can not be less than 20 operation, the air volume configuration for the high-end position; the production line heat transfer system under a good condition of the feed speed can be appropriately accelerated, the air volume can be equipped High-grade, but the exhaust condition of the chimney should be observed at any time, and smoke-free emission is the criterion for determining the feed rate;

3. Observe the change of water temperature from time to time, adjust the displacement, make it safe and save;

4, according to the change of energy consumption of the product, adjust the intermittent feeding amount of the heat preservation phase;

5. It is forbidden to open the upper and lower furnace doors when the furnace is burning.

Second, start management:

1, open the use of equipment power, water pipes are normal, check the cooling pool is enough water. Turn on the burner cooling water inlet and outlet valves, and confirm that the high-temperature combustion chamber is filled with cooling water;

2. Before the start of the burner, clean the carbon deposit in the furnace bridge, clean up the carbon deposit on the bottom of the furnace, add pellet fuel, close the lid of the material box, and open the partition valve;

3. Adjust the supply air position to a small value, put in the appropriate amount of material, and start the ignition. Lightly open the door and send the air properly. Close the furnace door, start the feeding system, and gradually adjust the air supply position to the right amount. The feeding speed and air supply volume should be gradually increased. It should not be accelerated too fast. There should be 23 minutes for the furnace temperature to rise normally. Safe operation is very important. If you follow safe operations, accidents will occur.